Return to Overview
Cannot find server.
Cannot use this function at this time.
Check that all of the covers are closed.
Check the cable.
Check the originals.
Clean the scan area.
This message shows the percentage of the memory currently available. This message is displayed when you set the originals in the feeder in Fax/Send mode.
If you need more space, wait for the machine to send any documents in memory. Also print, send, or delete any documents stored in memory.
The IP address that the machine should connect to cannot be determined.
Check the DNS (Domain Name System) Server Settings in TCP/IPv4 or v6 in Network Settings in System Management Set (from the Additional Functions screen).
You have specified the group addresses when the line is off the hook.
Specify the recipient other than group addresses.
You have specified the One-touch that has registered with other than fax number when the line is off the hook.
Make sure that the line is disconnected.
The registered group is already nested for three levels of subgroups (e.g., a group registered in a group in a group in a group).
You cannot register a group to contain more than three levels of subgroups. Modify the group so that it contains three levels of groups or less.
You selected the One-touch that has already been registered, when you are registering group addresses.
You selected group address that has already been registered, when you are registering a One-touch.
Register the One-touch that is not used.
The machine's TCP/IP is not operating.
Check the IP Address Settings in Network Settings in System Management Set (from the Additional Functions screen). (See "Setting and Checking the IP Address.")
The cover is open.
Check the cover and make sure that it is completely closed.
The machine and cable are not connected properly.
Turn OFF the machine, check that the machine is connected to the network using the proper cable, and then turn the machine ON.
Paper or originals are jammed.
Remove any jammed paper or originals. (See "Clearing Jams.")
The feeder scanning area may be dirty.
Clean the feeder scanning area (See "Scanning Area."), then press [OK].